Nissan Maxima Service and Repair Manual: Steering column covers

Removal and Installation

MANUAL TILT

Removal

Nissan Maxima. MANUAL TILT

  1. Remove the steering column cover screw finishers (1) and then remove the screws.
  2. Remove the steering column upper cover (2).
  3. Remove the steering column lower cover screw and then remove the steering column lower cover (3).

Installation

Installation is in the reverse order of removal.

POWER TILT

Removal

Nissan Maxima. POWER TILT

  1. Remove the steering column screw cover finishers (1) and then remove the screws.
  2. Remove the steering column upper cover (2).
  3. Remove the steering column side cover (LH) (4).
  4. Remove the steering column side cover (RH) (3).
  5. Remove the screws and then remove the steering column lower cover (5).

Installation

Installation is in the reverse order of removal.

    Instrument panel assembly
    Exploded View Center speaker grille (if equipped) Tweeter speaker grille (LH) Front defroster grille (LH) Instrument panel Instrument side finisher (LH) Lower knee protector (LH) ...

    Center console assembly
    Exploded View Center console side finisher (LH) Center console finisher CVT finisher Center console storage bin Center console screw cover (LH) Center console rear finisher Center ...

    Other materials:

    Low tire pressure warning lamp blinks
    Low Tire Pressure Warning Lamp Flashes When Ignition Switch Is Turned On NOTE: If low tire pressure warning lamp flashes as shown, the system is normal. Flash Mode A  This mode shows transmitter status is OFF-mode.Carry out transmitter wake up operation. DIAGNOSTIC PROCEDURE ...

    P0725 engine speed
    Description The engine speed signal is transmitted from ECM to TCM via CAN communication line. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: Immediately after performing any "DTC CONFIRMATION PROCEDURE", always turn igni ...

    Push-button ignition switch illumination circuit
    Description Provides the power supply and the ground to control the push-button ignition switch illumination. Component Function Check 1.CHECK PUSH-BUTTON IGNITION SWITCH ILLUMINATION OPERATION CONSULT Turn the ignition switch ON. Select "ENGINE SW ILLUMI" of BCM (INTELLGENT KEY) active ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0229