Precaution
PreparationEvap leak check
Inspection
CAUTION:
Never use compressed air or a high pressure pump.
Never exceed 4.12 kPa (0.042 kg/cm2, 0.6 psi) of pressure in
EVAP system.
NOTE:
Do not start engine.
Improper installation of EVAP service port adapter (commercial
service tool) ...
Sunroof system
System Diagram
SUNROOF
System Description
DESCRIPTION
Sunroof motor assembly and sunshade motor assembly operate with
the power supplied from BCM while ignition switch is ON or retained power
is operating.
Sunroof motor assembly receives an operation signal from sunroof
switch, a ...
B1209 - B1210 collision detection
Description
DTC B1209 - B1210 COLLISION DETECTION
The air bag diagnosis sensor unit will set this DTC if it has detected a
collision which has resulted in a frontalor side deployment of one or more
air bags or pre-tensioners. If this DTC is detected after a SRS repair, the air
bag diagnosis s ...