
The Intelligent Key contains the mechanical key, which can be used in case of a discharged battery.
To remove the mechanical key, release the lock knob on the back of the Intelligent Key.
To install the mechanical key, firmly insert it into the Intelligent Key until the lock knob returns to the lock position.
The mechanical key can be used for operation in the same way as an ordinary key.
CAUTION
Always carry the mechanical key installed in the Intelligent Key slot.
For additional information, refer to "Doors" in this section and "Storage" in the "Instruments and controls" section of this manual.
NISSAN Intelligent Key
Valet hand-offBoth doors mirror defogger don't operate but rear window
defogger operates
Diagnosis Procedure
1. CHECK DOOR MIRROR DEFORGGER FUSE
Check if the following fuse in fuse block (J/B) is blown.
2. CHECK DOOR MIRROR DEFORGGER CIRCUIT
Turn ignition switch OFF.
Disconnect the following harness connectors.
Fuse block (J/B) connector M5
Door mirror LH D4
Door ...
Can communication system
System Description
CAN communication is a multiplex communication system. This enables the
system to transmit and receive large quantities of data at high speed by connecting control units with two
communication lines (CAN-H and CAN-L).
Control units on the CAN network transmit signals usi ...
License lamp finisher
Exploded View
License lamp finisher
Trunk request switch connector
Grommet Clip
Removal and Installat
REMOVAL
Remove the trunk lid finisher. Refer to INT-36, "Removal and
Installation".
Disconnect the harness connector (1) from the trunk request
switch.
Remove the ...