Nissan Maxima Service and Repair Manual: License lamp finisher

Exploded View

Nissan Maxima. Exploded View

  1. License lamp finisher
  2. Trunk request switch connector
  3. Grommet
    Clip

Removal and Installat

REMOVAL

Nissan Maxima. Removal and Installat

  1. Remove the trunk lid finisher. Refer to INT-36, "Removal and Installation".
  2. Disconnect the harness connector (1) from the trunk request switch.
  3. Remove the license lamp finisher nuts.
  4. Release the clips, then loosen trunk request switch harness grommet from trunk.
  5. Remove license lamp finisher by pulling out and rearward away from trunk.

INSTALLATION

Installation is in the reverse order of removal.

    Roof side molding
    Exploded View Roof side molding Roof panel Body side panel  Roof side molding clip Removal and Installation REMOVAL Using suitable tool, lift and twist the roof side molding ...

    Rear spoiler
    Exploded View Rear spoiler assembly High-mounted stop lamp harness connector Harness grommet Removal and Installation Removal Remove trunk lid finisher. Refer to INT-36, "Remov ...

    Other materials:

    ECU diagnosis information
    BCM (BODY CONTROL MODULE) Reference Value NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information. Activate and display TPMS transmitter IDs Display tire pressure reported by the TPMS tra ...

    Basic inspection
    INSPECTION AND ADJUSTMENT Operational Check DESCRIPTION The purpose of the operational check is to check that the individual system operates normally. Conditions: Engine running at normal operating temperature INSPECTION PROCEDURE 1.CHECK MEMORY FUNCTION Start the engine. Operate the t ...

    Climate controlled seat
    Wiring Diagram ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0076