Nissan Maxima Owners Manual: Valet hand-off

When you have to leave a key with a valet, give them the Intelligent Key itself and keep the mechanical key with you to protect your belongings.

To prevent the glove box and the trunk from being opened during valet hand-off, follow the procedures below.

1. Push the trunk cancel switch to the OFF position.

2. Remove the mechanical key from the Intelligent Key.

3. Lock the glove box and the trunk passthrough with the mechanical key.

4. Hand the Intelligent Key to the valet and keep the mechanical key with you.

For additional information, refer to "Trunk lid" in this section, "Storage" in the "Instruments and controls" section and "Seats" in the "Safety- -Seats, seat belts and supplemental restraint system" section of this manual.

    Mechanical key
    The Intelligent Key contains the mechanical key, which can be used in case of a discharged battery. To remove the mechanical key, release the lock knob on the back of the Intelligent Key. ...

    NISSAN Vehicle Immobilizer System keys
    You can only drive your vehicle using the Intelligent Keys which are registered to the NISSAN Vehicle Immobilizer System components in your vehicle. The mechanical key can be used for all the lo ...

    Other materials:

    Installing front license plate
    Use the following steps to mount the front license plate: 1. Make holes on the plastic finisher at the location mark (small dimple) using a 5 mm (0.20 in) drill. Apply light pressure to the drill. Install the license plate holder using the two screws provided with the holder. 2. Mount ...

    P0327, P0328, P0332, P0333 KS
    Description The knock sensor is attached to the cylinder block. It senses engine knocking using a piezoelectric element. A knocking vibration from the cylinder block is sensed as vibrational pressure. This pressure is converted into a voltage signal and sent to the ECM. DTC Logic DTC DETE ...

    Washer level switch signal circuit
    Description Transmits the washer fluid level switch signal to the combination meter. Component Function Check 1.COMBINATION METER INPUT SIGNAL  Select "METER/M&A" on CONSULT.  Monitor "WASHER W/L" of "DATA MONITOR" under the following conditions. >> I ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.007