Description
The following functions are available when having and carrying the Intelligent Key.
Remote control entry function and panic alarm function are available when operating the remote buttons.
Component Function Check
NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.
1. CHECK FUNCTION
With CONSULT
Check remote keyless entry receiver RKE OPE COUN1 in Data Monitor mode with CONSULT.

Diagnosis Procedure
NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.
1. CHECK INTELLIGENT KEY BATTERY

Check by connecting a resistance (approximately 300Ω) so that the current value becomes about 10 mA.
Standard : Approx. 2. 5 - 3. 0V
2. CHECK KEYFOB FUNCTION

Check keyfob function using Signal Tech II Tool J-50190 or Remote Keyless Entry Tester J-43241 (shown).
Remote keyless entry receiver
Key slot illuminationRemoval and Installation
REMOVAL
Disconnect the battery negative terminal. Refer to PG-67, "Removal
and Installation (Battery)".
Disconnect the harness connector from the accelerator position
sensor.
Remove the three accelerator pedal nuts.
Remove the accelerator pedal and accelerator position sensor assembl ...
Headlights
Replacing the halogen headlight bulb
(if so equipped)
The headlight is a semi-sealed beam type which
uses a replaceable headlight (halogen) bulb.
They can be replaced from inside the engine
compartment without removing the headlight assembly.
If headlight bulb replacement is required, it i ...
Three-point type seat belt with retractor
WARNING
Every person who drives or rides in this
vehicle should use a seat belt at all
times. Children should be in the rear
seats and in an appropriate restraint.
Do not ride in a moving vehicle when
the seatback is reclined. This can be
dangerous. The shoulder belt will not
be ag ...