Nissan Maxima Service and Repair Manual: P1611 ID discord, IMMU-ECM

Description

BCM performs the ID verification with ECM that allows the engine to start. Start the engine if the ID is OK.

ECM prevents the engine from starting if the ID is not registered. BCM starts the communication with ECM if ignition switch is turned ON.

DTC Logic

DTC DETECTION LOGIC

NOTE:

  • If DTC P1611 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC-29, "DTC Logic".

  • If DTC P1611 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to SEC-30, "DTC Logic".

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

  1.  Turn ignition switch ON under the following conditions:

    • CVT selector lever is in the P or N position.

    • Do not depress the brake pedal.

  2.  Check "Self Diagnostic Result" with CONSULT.

Diagnosis Procedure

1.PERFORM INITIALIZATION

Perform initialization with CONSULT. Re-register all Intelligent Keys.

For initialization and registration of Intelligent Key, refer to "CONSULT Immobilizer mode and follow the onscreen instructions.

    P1610 lock mode
    Description Performs ID verification through BCM and Intelligent Key when push-button ignition switch is pressed. Prohibits the start of engine when an unregistered ID of Intelligent Key is us ...

    P1612 chain of ECM-IMMU
    Description BCM performs the ID verification with ECM that allows the engine to start. Start the engine if the ID is OK. ECM prevents the engine from starting if the ID is not registered. BCM st ...

    Other materials:

    Automatic air conditioner system
    System Diagram CONTROL SYSTEM The control system consists of input sensors, switches, the A/C auto amp. (microcomputer) and outputs. The relationship of these components is as shown in the figure below: System Description CONTROL OPERATION Display The operation status of the HVAC system ...

    Engine compartment
    WARNING Never use a fuse of a higher or lower amperage rating than specified on the fuse box cover. This could damage the electrical system or electronic control units or cause a fire. If any electrical equipment does not come on, check for an open fuse. 1. Be sure the ignition switch ...

    Unit removal and installation
    TRANSAXLE ASSEMBLY Exploded View  Air breather hose  CVT fluid level gauge  CVT fluid charging pipe  O-ring  Copper sealing washer  Fluid cooler tube  Transaxle assembly A. Refer to INSTALLATION. ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0177