Nissan Maxima Service and Repair Manual: Removal and installation

Periodic maintenance

PRE-INSPECTION FOR DIAGNOSTIC Basic Inspection BASIC INSPECTION 1.INSPECTION START Check the service history. Check the following parts. Fuse/circuit breaker blown. Poor connection, o ...

Main power window and door lock/unlock switch

Removal and Installation REMOVAL Remove the front door grip cover. Refer to DLK-214, "FRONT DOOR : Removal and Installation". Remove the clip (A) from the door grip using a suitabl ...

Other materials:

RCTA system operation
1. Side BSW/RCTA Indicator Light 2. BSW/RCTA Indicator The RCTA system can help alert the driver of an approaching vehicle when the driver is backing out of a parking space. When the shift position is in R (Reverse) and the vehicle speed is less than approximately 5 mph (8 km/h), the RC ...

U1000 Can comm circuit
Description DTC Logic DTC DETECTION LOGIC NOTE: U1000 can be set if a module harness was disconnected and reconnected, perhaps during a repair. Confirm that there are actual CAN diagnostic symptoms and a present DTC by performing the Self Diagnostic Result procedure. Diagnosis Proc ...

Turn signal and hazard warning lamps
System Diagram System Description BCM (Body Control Module) controls turn signal lamp (RH and LH) and hazard warning lamp operation. Combination meter operates turn signal indicator (RH and LH) according to CAN communication signals from BCM. Component Parts Location BCM M1 ...