Nissan Maxima Service and Repair Manual: System description

Inspection and adjustment

ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Description MEMORY RESET PROCEDURE Please observe the following instructions at confirming the sun ...

Sunroof system

System Diagr SUNROOF System Description SUNROOF SYSTEM INPUT/OUTPUT SIGNAL CHART SUNROOF OPERATION Sunroof motor assembly operates with the power supply that is output from BCM while ...

Other materials:

IPDM E/R (intelligent power distribution module engine room)
Reference Value VALUES ON THE DIAGNOSIS TOOL TERMINAL LAYOUT PHYSICAL VALUES Fail Safe CAN COMMUNICATION CONTROL When CAN communication with ECM and BCM is impossible, IPDM E/R performs fail-safe control. After CAN communication recovers normally, it also returns to nor ...

Condenser
CONDENSER CONDENSER : Removal and Installation REMOVAL Discharge the refrigerant. Refer to HA-28, "Recycle Refrigerant". Remove the RH hoodledge cover. Remove the front bumper fascia. Refer to EXT-16, "Removal and Installation". Disconnect the high-pressure pipe from the condenser pip ...

B2581, B2582 intake sensor
Description Intake Sensor The intake sensor is located on the evaporator. It converts air temperature after it passes through the evaporator into a resistance value which is then input to the A/C auto amp. Intake Sensor Circuit DTC Logic DTC DETECTION LOGIC NOTE: If DTC is di ...