Nissan Maxima Service and Repair Manual: Communication signal circuit

Description

Detects door open/close condition.

Diagnosis Procedure

1.CHECK FRONT DOOR SWITCH INPUT SIGNAL

  1. Turn ignition switch OFF.
  2. Disconnect sunshade motor assembly connector.
  3. Turn ignition switch ON.
  4. Check signal between sunshade motor assembly harness connector and ground with oscilloscope.

Nissan Maxima. CHECK FRONT DOOR SWITCH INPUT SIGNAL

2.CHECK COMMUNICATION SIGNAL CIRCUIT

Nissan Maxima. .CHECK COMMUNICATION SIGNAL CIRCUIT

Nissan Maxima. .CHECK COMMUNICATION SIGNAL CIRCUIT

  1. Turn ignition switch OFF.
  2. Disconnect sunroof motor assembly connector.
  3. Check continuity between sunshade motor assembly harness connector (A) and sunroof motor assembly harness connector (B).
  4. Check continuity between sunshade motor assembly harness connector and ground.

    Power supply and ground circuit
    BCM BCM : Diagnosis Proce 1. CHECK FUSE AND FUSIBLE LINK Check if the following BCM fuses or fusible link are blow 2. CHECK POWER SUPPLY CIRCUIT Turn ignition switch OFF. Disconnect BCM. ...

    Sunroof switch
    Description Transmits switch operation signal to sunroof motor assembly. Diagnosis Procedure 1.CHECK SUNROOF SWITCH INPUT SIGNAL Turn ignition switch ON. Check voltage between sunroof mot ...

    Other materials:

    Front combination lamp
    Exploded View Front combination lam Removal and Installation FRONT COMBINATION LAMP Removal Remove the front bumper fascia. Refer to EXT-16, "Removal and Installation". Remove the front combination lamp bolts. Remove the harness clips from the front combination lamp assembly. ...

    P0507 ISC system
    Description The ECM controls the engine idle speed to a specified level via the fine adjustment of the air, which is let into the intake manifold, by operating the electric throttle control actuator. The operating of the throttle valve is varied to allow for optimum control of the engine id ...

    P0840 transmission fluid pressure SEN/SW A
    The secondary pressure sensor detects secondary pressure of CVT and sends a signal to the TCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE NOTE: Immediately after performing any "DTC CONFIRMATION PROCEDURE", always turn ignition switch OFF. Then wait at least 10 seconds b ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0094