Nissan Maxima Service and Repair Manual: Unit disassembly and assembly

License plate lamp
Exploded View License plate lamp Removal and Installation LICENSE PLATE LAMP Removal Remove the license lamp finisher. Refer to EXT-31, "Removal and Installation". Position trunk ...

Front combination lamp
Disassembly and Assembly EXPLODED VIEW Front combination lamp Xenon bulb Plastic cover Side marker lamp socket Side marker lamp bulb Front turn signal lamp socket Front turn sig ...

Other materials:

System maintenance
The two radar sensors 1 for the BSW and RCTA systems are located near the rear bumper. Always keep the area near the radar sensors clean. The radar sensors may be blocked by temporary ambient conditions such as splashing water, mist or fog. The blocked condition may also be caused b ...

Predictive Forward Collision Warning (PFCW) (if so equipped)
WARNING Failure to follow the warnings and instructions for proper use of the PFCW system could result in serious injury or death. The PFCW system can help warn the driver before a collision occurs but will not avoid a collision. It is the driver's responsibility to stay alert, drive sa ...

System maintenance
The sensor A is located behind the lower grille of the front bumper. To keep the system operating properly, be sure to observe the following: Always keep the sensor area of the front bumper clean. Do not strike or damage the areas around the sensor. Do not cover or attach st ...

Nissan Maxima Owners Manual

Nissan Maxima Service and Repair Manual

© 2017-2026 Copyright www.nimainfo.com
0.0095