Nissan Maxima Service and Repair Manual: Both side headlamps (LO) are not turned on

Both side headlamps do not switch to high beam

Description The headlamps (both sides) do not switch to high beam when the lighting switch is in the HI or PASS setting. Diagnosis Procedure 1.COMBINATION SWITCH (LIGHTING AND TURN SIGNAL SWITCH) ...

Parking, license plate and tail lamps are not turned on

Description The parking, license plate and tail lamps do not turn ON in with any lighting switch setting. Diagnosis Procedure 1.COMBINATION SWITCH (LIGHTING AND TURN SIGNAL SWITCH) INSPECTION Ch ...

Other materials:

P0703 brake switch B
Description BCM detects ON/OFF state of the stop lamp switch and transmits the data to the TCM via CAN communication by converting the data to a signal. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: Immediately after perform ...

Tilt&telescopic switch
Removal and Installation REMOVAL Remove the steering column side cover (LH) (1). Refer to IP-13, "Removal and Installation". Release the pawls and remove tilt & telescopic switch (2) from the steering column side cover (LH) (1). : Pawl INSTALLATION Installation is in the re ...

Automatic speed control device (ASCD)
System Diagram System Description INPUT/OUTPUT SIGNAL CHART *: This signal is sent to the ECM via the CAN communication line BASIC ASCD SYSTEM Refer to Owner's Manual for ASCD operating instructions. Automatic Speed Control Device (ASCD) allows a driver to keep vehicle at predeterm ...