Nissan Maxima Service and Repair Manual: Parking, license plate and tail lamps are not turned on

Nissan Maxima Service and Repair Manual / Driver controls / Exterior lighting system / Symptom diagnosis / Parking, license plate and tail lamps are not turned on

Description

The parking, license plate and tail lamps do not turn ON in with any lighting switch setting.

Diagnosis Procedure

1.COMBINATION SWITCH (LIGHTING AND TURN SIGNAL SWITCH) INSPECTION

Check the combination switch (lighting and turn signal switch).

2.CHECK TAIL LAMP RELAY REQUEST SIGNAL INPUT

CONSULT DATA MONITOR

  1. Select "TAIL & CLR REQ" of IPDM E/R DATA MONITOR item.
  2. While operating the lighting switch, check the monitor status.

Nissan Maxima. CHECK TAIL LAMP RELAY REQUEST SIGNAL INPUT

3.PARK LAMP CIRCUIT INSPECTION

Check the parking lamp circuit

    Both side headlamps (LO) are not turned on
    Description The headlamps (both sides) do not turn ON in any lighting switch setting. Diagnosis Procedure 1.CHECK COMBINATION SWITCH (LIGHTING AND TURN SIGNAL SWITCH) Check the combination switch ...

    Both side front fog lamps are not turned on
    Description The front fog lamps do not turn ON in any setting. Diagnosis Procedure 1.COMBINATION SWITCH (LIGHTING AND TURN SIGNAL SWITCH) INSPECTION Check the combination switch (lighting and turn ...

    Other materials:

    Service data and specifications (SDS)
    General Specification (Rear) Wheel Alignment (Unladen*1) *1: Fuel, engine coolant, and lubricants are full. Spare tire, jack, hand tools, and mats are in designated positions. *2: 18" tire. *3: 19" tire. Ball Joint Wheelarch Height (Unladen*1) *1: Fuel, engine coolant, and lub ...

    Locking doors
    1. Move the shift lever to the P (Park) position, place the ignition switch in the LOCK position and make sure you carry the Intelligent Key with you. 2. Close all doors. 3. Push any door handle request switch while carrying the Intelligent Key with you. 4. All doors will lock. 5 ...

    B2603 shift position status
    Description BCM confirms the shift position with the following 2 signals.  CVT selector lever  P/N position switch DTC Logic DTC DETECTION LOGIC NOTE: If DTC B2603 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0076