Back-up lamp
Exterior lighting system symptomsRemoval and Installation
REMOVAL
Disconnect the battery negative terminal. Refer to PG-67, "Removal
and Installation (Battery)".
Disconnect the harness connector from the accelerator position
sensor.
Remove the three accelerator pedal nuts.
Remove the accelerator pedal and accelerator position sensor assembl ...
Tilt &telescopic switch ground circuit
Diagnosis Procedure
1. CHECK ADP STEERING SWITCH (TILT & TELESCOPIC SWITCH) GROUND CIRCUIT
Turn ignition switch OFF.
Disconnect ADP steering switch (tilt & telescopic switch).
Check continuity between ADP steering switch (tilt & telescopic
switch) and ground.
...
P1778 step motor
Description
The step motor changes the step by turning 4
coils ON/OFF according to the signal from TCM. As a result,
the flow of line pressure to primary pulley is changed and pulley ratio is
controlled.
This diagnosis item is detected when the
electrical syste ...