Nissan Maxima Service and Repair Manual: Normal operating condition

Description

FRONT WIPER MOTOR PROTECTION FUNCTION

  • IPDM E/R may stop the front wiper to protect the front wiper motor if any obstruction (operation resistance)
    such as a large amount of snow is detected during the front wiper operation.
  • At that time turn OFF the front wiper and remove the foreign object. Then wait for approximately 20 seconds
    or more and reactivate the front wiper. The wiper will operate normally.
    Front wiper does not operate
    Description The front wiper does not operate under any operation conditions Diagnosis Procedure 1. CHECK WIPER RELAY OPERATION IPDM E/R AUTO ACTIVE TEST Start IPDM E/R auto active test. Refer ...

    Precaution
    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELTPRE-TENSIONER" The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", used alongwith a front ...

    Other materials:

    U1010 control unit (CAN)
    Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent malfunction detection ability. Many electronic control units are equipped onto a vehicle, an ...

    TCM
    Exploded View  Bracket  TCM Vehicle front Removal and Installation CAUTION:  Do not impact the TCM when removing or installing TCM.  When replacing TCM and transaxle assembly as a set, replace transaxle assembly first and then r ...

    Push-button ignition switch illumination circuit
    Description Provides the power supply and the ground to control the push-button ignition switch illumination. Component Function Check 1.CHECK PUSH-BUTTON IGNITION SWITCH ILLUMINATION OPERATION CONSULT Turn the ignition switch ON. Select "ENGINE SW ILLUMI" of BCM (INTELLGENT KEY) active ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0179