Nissan Maxima Service and Repair Manual: Additional service when replacing control unit (bcm)

Nissan Maxima Service and Repair Manual / Power outlet / Body control system / Basic inspection / Additional service when replacing control unit (bcm)

ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM) : Description

BEFORE REPLACEMENT

When replacing BCM, save or print current vehicle specification with CONSULT configuration before replacement.

NOTE: If "Before Replace ECU" cannot be used, use the "After Replace ECU" or "Manual Configuration" after replacing BCM.

AFTER REPLACEMENT

CAUTION:

  • When replacing BCM, you must perform "After Replace ECU" with CONSULT.
  • Complete the procedure of "After Replace ECU" in order.
  • If you set incorrect "After Replace ECU ", incidents might occur.
  • Configuration is different for each vehicle model. Confirm configuration of each vehicle model.
  • When replacing BCM, perform the system initialization (NATS).

ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM) : Work Procedure

1.SAVING VEHICLE SPECIFICATION

CONSULT

Enter "Re/Programming, Configuration" and perform "Before Replace ECU" to save or print current vehicle specification.

NOTE: If "Before Replace ECU" cannot be used, use the "After Replace ECU" or "Manual Configuration" after replacing BCM.

2.REPLACE BCM

3.WRITING VEHICLE SPECIFICATION

CONSULT

  1. Enter "Re/Programming, Configuration ".
  2. If "Before Replace ECU" operation was performed, automatically an "Operation Log Selection" screen will be displayed. Select the applicable file from the "Saved Data List" and press "Confirm" to write vehicle specification. Refer to BCS-6, "CONFIGURATION (BCM) : Work Procedure ".
  3. If "Before Replace ECU" operation was not performed, select "After Replace ECU" or "Manual Configuration" to write vehicle specification. Refer to BCS-6, "CONFIGURATION (BCM) : Work Procedure ".

4.INITIALIZE BCM (NATS)

Perform BCM initialization. (NATS)

    Diagnosis and repair workflow
    Work Flow OVERALL SEQUENCE DETAILED FLOW 1. GET INFORMATION FOR SYMPTOM Get the detailed information from the customer about the symptom (the condition and the environment when the inciden ...

    Configuration (BCM)
    CONFIGURATION (BCM) : Description Vehicle specification needs to be written with CONSULT because it is not written after replacing BCM. Configuration has three functions as follows F ...

    Other materials:

    Folding rear seat
    Interior trunk access The trunk can be accessed from the passenger side of the rear seat for loading and unloading, as shown. 1. Move the front passenger seat to the most forward position. 2. Open the access cover on the rear parcel shelf. 3. Push down on the button 1 on the rear pa ...

    P0102, P0103 MAF sensor
    Description The mass air flow sensor (1) is placed in the stream of intake air. It measures the intake flow rate by measuring a part of the entire intake flow. The mass air flow sensor controls the temperature of the hot wire to a certain amount. The heat generated by the hot wire is re ...

    Periodic maintenance
    FUEL SYSTEM Inspection Inspect fuel lines, fuel filler cap and fuel tank for improper attachment, leaks, cracks, damage, loose connections, chafing or deterioration. If necessary, repair or replace damaged parts. Quick Connector CAUTION:  After connecting fuel tube quick connec ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.012