Nissan Maxima Service and Repair Manual: A-bag branch line circuit

Diagnosis Procedure

WARNING:

Always observe the following items for preventing accidental activation.

  • Before servicing, turn ignition switch OFF, disconnect battery negative terminal, and wait 3 minutes or more. (To discharge backup capacitor.)
  • Never use unspecified tester or other measuring device.

1.CHECK CONNECTOR

  1. Turn the ignition switch OFF.
  2. Disconnect the battery cable from the negative terminal.
  3. Check the terminals and connectors of the air bag diagnosis sensor unit for damage, bend and loose connection (unit side and connector side).

2.CHECK AIR BAG DIAGNOSIS SENSOR UNIT

Check the air bag diagnosis sensor unit. Refer to SRC-3, "Work Flow".

    STRG branch line circuit
    Diagnosis Procedure 1.CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the steering angle sensor ...

    ABS branch line circuit
    Diagnosis Procedure 1.CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the ABS actuator and elec ...

    Other materials:

    Audio antenna
    Location of Antenna AV control unit AV control unit antenna feeder In-line connectors M103, M501 Antenna amp. Window antenna Satellite radio antenna feeder Satellite radio antenna Window Antenna Repair ELEMENT CHECK Attach probe circuit tester (ohm setting) to antenna ...

    Rear window defogger and door mirror defogger do not operate
    Diagnosis Procedure 1. CHECK REAR WINDOW DEFOGGER SWITCH Check rear window defogger switch. 2. CHECK REAR WINDOW DEFOGGER RELAY Check rear window defogger relay 3. CHECK FUSES Check if any of the following fuses in fuse block (J/B) are blown. 4. CHECK REAR WINDOW DEFOGGER POWER SUPPLY CIR ...

    Parking lamp circuit
    Description The IPDM E/R (intelligent power distribution module engine room) controls the tail lamp relay based on inputs from the BCM over the CAN communication lines. When the tail lamp relay is energized, power flows through fuses 46 and 47, located in the IPDM E/R. Power then flows to the ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0083