Nissan Maxima Service and Repair Manual: B2099 ignition relay off stuck

B2098 ignition relay on stuck

DTC Logic DTC DETECTION LOGIC 1.PERFORM DTC CONFIRMATION PROCEDURE Turn the power supply position to start under the following conditions and wait for at least 1 second. CVT selecto ...

Power supply and ground circuit

Diagnosis Procedure 1. CHECK FUSES AND FUSIBLE LINK Check that the following IPDM E/R fuses or fusible link are not blown. 2. CHECK POWER SUPPLY CIRCUIT Turn ignition switch OFF. Disconne ...

Other materials:

Periodic maintenance
FUEL SYSTEM Inspection Inspect fuel lines, fuel filler cap and fuel tank for improper attachment, leaks, cracks, damage, loose connections, chafing or deterioration. If necessary, repair or replace damaged parts. Quick Connector CAUTION:  After connecting fuel tube quick connec ...

System maintenance
The sensor A is located behind the lower grille of the front bumper. To keep the system operating properly, be sure to observe the following: Always keep the sensor area of the front bumper clean. Do not strike or damage the areas around the sensor. Do not cover or attach st ...

U1000 CAN comm circuit
Description DTC Logic DTC DETECTION LOGIC NOTE: U1000 can be set if a module harness was disconnected and reconnected, perhaps during a repair. Confirm that there are actual CAN diagnostic symptoms and a present DTC by performing the Self Diagnostic Result procedure. Diagnosis Proc ...