Nissan Maxima Service and Repair Manual: DTC/circuit diagnosis

Diagnosis system (IPDM E/R)

Diagnosis Description AUTO ACTIVE TEST Description In auto active test mode, the IPDM E/R sends a drive signal to the following systems to check their operation. Oil pressure warning lamp F ...

U1000 CAN comm circuit

Description DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1. PERFORM SELF DIAGNOSTIC Turn ignition switch ON and wait for 2 seconds or more. Check "Self Diagnostic Result" of IPDM E/ ...

Other materials:

C1142 press sen circuit
Description The pressure sensor converts the brake fluid pressure to an electric signal and transmits it to the ABS actuator and electric unit (control unit). (The pressure sensor is integrated in the ABS actuator and electric unit (control unit).) DTC Logic DTC DETECTION LOGIC DTC C ...

Power supply and ground circuit
Diagnosis Procedure 1. CHECK FUSES AND FUSIBLE LINK Check that the following IPDM E/R fuses or fusible link are not blown. 2. CHECK POWER SUPPLY CIRCUIT Turn ignition switch OFF. Disconnect IPDM E/R connectors. Check voltage between IPDM E/R harness connector and ground. 3. CHE ...

License lamp finisher
Exploded View License lamp finisher Trunk request switch connector Grommet Clip Removal and Installat REMOVAL Remove the trunk lid finisher. Refer to INT-36, "Removal and Installation". Disconnect the harness connector (1) from the trunk request switch. Remove the ...