DTC Logic
DTC DETECTION LOGIC

1.PERFORM DTC CONFIRMATION PROCEDURE
Diagnosis Procedure
1. PERFORM SELF DIAGNOSTIC RESULT
Perform Self Diagnostic Result of IPDM E/R using CONSULT.
U1000 CAN comm circuit
B2099 ignition relay off stuckFront drive shaft
Removal and Installation (LH)
Drive shaft
Cotter pin
REMOVAL
Remove wheel and tire using power tool. Refer to WT-60, "Adjustment".
Remove wheel sensor from steering knuckle. Refer to BRC-102,
"Removal and Installation - Front Wheel Sensor".CAUTION: Do not
pull o ...
Turn signal and hazard warning lamps
System Diagram
System Description
BCM (Body Control Module) controls turn signal lamp (RH and LH) and
hazard warning lamp operation
Combination meter operates turn signal indicator (RH and LH)
according to CAN communication signals from BCM.
Component Parts Location
BCM M16 ...
S connector circuit
Description
The starter motor magnetic switch is supplied with power when the ignition
switch is turned to the START position while the selector lever is in the P
or N position.
Diagnosis Procedure
CAUTION: Perform diagnosis under the condition that
engine cannot start by the fo ...