Nissan Maxima Service and Repair Manual: System description

Basic inspection
DIAGNOSIS AND REPAIR WORKFLOW Work Flow (With EXP-800 NI or GR8-1200 NI) CHARGING SYSTEM DIAGNOSIS WITH EXP-800 NI OR GR8-1200 NI To test the charging system, use the following special service tool ...

Charging system
System Diagram System Description The generator provides DC voltage to operate the vehicle's electrical system and to keep the battery charged. The voltage output is controlled by the IC re ...

Other materials:

P1709 incompleted data writing
Description When TCM does not store calibration data (individual characteristic value) of each solenoid valve that is stored in the ROM assembly (in the control valve), a malfunction is detected. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE NOTE: Immediately after performing ...

Door key cylinder switch
Description The main power window and door lock/unlock switch detects condition of the door key cylinder switch and transmits to BCM as the LOCK or UNLOCK signal. Component Function Check 1.CHECK DOOR KEY CYLINDER SWITCH INPUT SIGNAL Check KEY CYL UN-SW, KEY CYL UN-SW in "DATA MONITOR" mode ...

CVT fluid
Inspection CHECKING CVT FLUID The fluid level should be checked with the fluid warmed up to 50 to 80C (122 to 176F). The fluid level check procedure is as follows:  Check for fluid leakage.  With the engine warmed up, drive the vehicle in an urban area. When amb ...

Nissan Maxima Owners Manual

Nissan Maxima Service and Repair Manual

© 2017-2026 Copyright www.nimainfo.com
0.038