Description
The terminal "L" circuit controls the charge warning lamp. The charge warning lamp turns ON when the ignition switch is set to ON or START. When the generator is providing sufficient voltage with the engine running, the charge warning lamp turns off. If the charge warning lamp illuminates with the engine running, a malfunction is indicated.
Diagnosis Procedure
1.CHECK "L" TERMINAL CIRCUIT (SHORT)
2.CHECK HARNESS CONTINUITY (SHORT CIRCUIT)

L terminal circuit (open)
Wiring diagramBody component parts
Underbody Component Parts
Rear seat lower crossmember
Rear floor front
Rear floor front extension
Rear seat crossmember
Front side member rear extension
(LH/RH)
Dash side (LH/RH)
Hoodledge reinforcement (LH/RH)
Hoodledge lower assembly (LH/RH)
Front suspension spring s ...
Front wiper does not operate
Description
The front wiper does not operate under any operation conditions
Diagnosis Procedure
1. CHECK WIPER RELAY OPERATION
IPDM E/R AUTO ACTIVE TEST
Start IPDM E/R auto active test. Refer to PCS-11, "Diagnosis
Description".
Check that the front wiper operates at the LO/HI operation. ...
P0172, P0175 fuel injection system function
DTC Logic
DTC DETECTION LOGIC
With the Air/Fuel Mixture Ratio Self-Learning Control, the actual mixture
ratio can be brought closely to the
theoretical mixture ratio based on the mixture ratio feedback signal from A/F
sensor 1. The ECM calculates
the necessary compensation to correct the o ...