Nissan Maxima Service and Repair Manual: Basic inspection

Power supply, ground & circuit elements

...

Battery

How to Handle Battery CAUTION: If it becomes necessary to start the engine with a booster battery and jumper cables, use a 12-volt booster battery. After connecting battery cables, ensure ...

Other materials:

Condenser
Removal and Installation REMOVAL Remove the rear pillar finisher LH. Refer to INT-24, "Removal and Installation". Disconnect the harness connector, remove bolt (A), and then remove condenser (1) from the vehicle body. INSTALLATION Installation is in the reverse order of ...

Microphone signal circuit
Description Voice signals are transmitted from the microphone to the AV control unit using the microphone signal circuits. Diagnosis Procedure 1.CHECK HARNESS BETWEEN AV CONTROL UNIT AND MICROPHONE Turn ignition switch OFF. Disconnect AV control unit connector and microphone connector ...

Front door speaker
Removal and Installation REMOVAL Remove the front door finisher. Refer to INT-18, "Removal and Installation". Remove the front door speaker screws (A). Disconnect the harness connector from the front door speaker (1) and remove. Remove the front door speaker spacer screws (B) and ...