Nissan Maxima Service and Repair Manual: Unit disassembly and assembly

COMBINATION METER

Disassembly and Assembly

DISASSEMBLY

  1.  Remove the combination meter. Refer to MWI-122, "Removal and Installation".

  2.  Remove the combination meter lens (1) from the combination meter (2).

ASSEMBLY

Assembly is in the reverse order of disassembly.

    Meter control switch
    Removal and Installation REMOVAL  Disconnect the negative battery terminal. Refer to PG-67, "Removal and Installation (Battery)".  Remove the cluster lid A. Refer to IP-16 ...

    Warning chime system
    ...

    Other materials:

    ECM branch line circuit
    Diagnosis Procedure 1.CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side). - Models without automatic drive positione ...

    Antenna AMP
    Removal and Installation REMOVAL Remove the rear pillar finisher RH. Refer to INT-23, "Exploded View". Detach the antenna amp. harness clip (A). Disconnect the harness connectors (B) from the antenna amp. (1). Remove the antenna amp. screw (C) and the antenna amp. (1). INSTALLAT ...

    Uniform tire quality grading
    DOT (Department of Transportation) Quality Grades: All passenger car tires must conform to federal safety requirements in addition to these grades. Quality grades can be found where applicable on the tire sidewall between tread shoulder and maximum section width. For example: Treadwear 200 ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2019 Copyright www.nimainfo.com
    0.011