Description
The audio unit sends audio signals to the BOSE speaker amp. The BOSE speaker amp. amplifies the audio signals before sending them to the center speaker using the audio signal circuits.
Diagnosis Procedure
1.CONNECTOR CHECK
Check the audio unit, BOSE speaker amp. and speaker connectors for the following:
2.HARNESS CHECK



3.CENTER SPEAKER SIGNAL CECK


4.HARNESS CHECK

connector B109.


5.CENTER SPEAKER SIGNAL CHECK


Tweeter
Rear door speakerKey slot
Removal and Installation
REMOVAL
Remove the instrument lower panel LH. Refer to
IP-19, "Removal and Installation".
Remove the switch assembly screws (A), remove
the key slot
screws (B) and then remove key slot (1) from instrument lower
panel LH (2).
IN ...
RCTA system limitations
WARNING
Listed below are the system limitations for
the RCTA system. Failure to operate the
vehicle in accordance with these system
limitations could result in serious injury or
death.
Always check surroundings and turn to
check what is behind you before backing
up. The radar sensors det ...
Multiport fuel injection system
System Diagram
System Description
INPUT/OUTPUT SIGNAL CHART
*1: This sensor is not used to control the engine system under normal
conditions.
*2: This signal is sent to the ECM via the CAN communication line.
*3: ECM determines the start signal status by the signals of engine speed ...