Description
Component Function Check
1. CHECK OPERATION OF METER BUZZER
Diagnosis Procedure
1. CHECK POWER SUPPLY OF COMBINATION METER
Check power supply of combination meter. Refer to MWI-37, "COMBINATION METER : Diagnosis Procedure".
DTC/circuit diagnosis
Seat belt buckle switch signal circuitPrecaution
PRECAUTIONS
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT
BELT
PRE-TENSIONER"
The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER",
used along
with a front seat belt, helps to reduce the risk or severity of injury to ...
Low tire pressure warning lamp blinks
Low Tire Pressure Warning Lamp Flashes When Ignition Switch Is Turned
On
NOTE: If low tire pressure warning lamp flashes as
shown, the system is normal.
Flash Mode A
This mode shows transmitter status is OFF-mode.Carry out
transmitter wake up operation.
DIAGNOSTIC PROCEDURE ...
Illumination
Removal and Installation
TRUNK ROOM LAMP
Removal
Release the tab (A), then swing open the lens.
: Front
Remove the bulb (3).
Release the tab (B), then pull trunk room lamp (2) away from
body opening.
Disconnect the connector (1) and remove trunk room lamp
Installation
Install ...