Nissan Maxima Service and Repair Manual: ECU diagnosis information

Seat belt buckle switch signal circuit

Description Transmits a seat belt buckle switch LH signal to the combination meter. Component Function Check 1. CHECK COMBINATION METER INPUT SIGNAL Start engine. Monitor seat belt warning la ...

Combination meter

Reference Value VALUES ON THE DIAGNOSIS TOOL NOTE: * The monitor will indicate "OFF" even though the brake warning lamp is on if either of the following conditions exist: The parking br ...

Other materials:

Off-road recovery
While driving, the right side or left side wheels may unintentionally leave the road surface. If this occurs, maintain control of the vehicle by following the procedure below. Please note that this procedure is only a general guide. The vehicle must be driven as appropriate based on the conditi ...

Antenna AMP
Removal and Installation REMOVAL Remove the rear pillar finisher RH. Refer to INT-23, "Exploded View". Detach the antenna amp. harness clip (A). Disconnect the harness connectors (B) from the antenna amp. (1). Remove the antenna amp. screw (C) and the antenna amp. (1). INSTALLAT ...

v DLC and HVAC circuit
Diagnosis Procedure 1.CHECK HARNESS CONTINUITY (OPEN CIRCUIT) Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Disconnect the following harness connectors. ECM A/C auto amp. Check the continuity between the data link connector and the A/C ...