Nissan Maxima Service and Repair Manual: Microphone

Antenna AMP

Removal and Installation REMOVAL Remove the rear pillar finisher RH. Refer to INT-23, "Exploded View". Detach the antenna amp. harness clip (A). Disconnect the harness connectors (B) fro ...

Tel antenna

Removal and Instalation REMOVAL Disconnect the battery negative terminal. Refer to PG-67, "Removal and Installation (Battery)". Remove the rear parcel shelf finisher. Refer to INT-28, "R ...

Other materials:

If your vehicle overheats
If your vehicle is overheating (indicated by an extremely high temperature gauge reading) or if you feel a lack of engine power, detect abnormal noise, etc., take the following steps. WARNING Do not continue to drive if your vehicle overheats. Doing so could cause engine damage or a vehi ...

B1209 - B1210 collision detection
Description DTC B1209 - B1210 COLLISION DETECTION The air bag diagnosis sensor unit will set this DTC if it has detected a collision which has resulted in a frontalor side deployment of one or more air bags or pre-tensioners. If this DTC is detected after a SRS repair, the air bag diagnosis s ...

Power steering
WARNING If the engine is not running or is turned off while driving, the power assist for the steering will not work. Steering will be harder to operate. When the power steering warning light illuminates with the engine running, there will be no power assist for the steering. You w ...