Nissan Maxima Service and Repair Manual: Satellite radio antenna

Removal and Installation

REMOVAL

Nissan Maxima. REMOVAL

  1. Lower the headlining at the rear. Refer to INT-33, "Exploded View".
  2. Disconnect the harness connector (A) from satellite radio antenna.
  3. Remove the satellite radio antenna nut (B) and the satellite radio antenna (1).

INSTALLATION

Installation is in the reverse order of removal.

    Satellite radio tuner
    Removal and Installation REMOVAL Disconnect the battery negative terminal. Remove the trunk upper finisher. Refer to INT-36, "Exploded View". Remove the parcel shelf finisher. Refer to INT- ...

    Steering switch
    Removal and Installation REMOVAL Remove the driver airbag module. Refer to SR-12, "Removal and Installation". Remove the steering wheel audio control switch screws (A). Release the steer ...

    Other materials:

    P0037, P0038, P0057, P0058 HO2S2 heater
    Description SYSTEM DESCRIPTION The ECM performs ON/OFF control of the heated oxygen sensor 2 heater corresponding to the engine speed, amount of intake air and engine coolant temperature. OPERATION DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DT ...

    Ignition signal
    Description The ignition signal from the ECM is sent to and amplified by the power transistor. The power transistor turns ON and OFF the ignition coil primary circuit. This ON/OFF operation induces the proper high voltage in the coil secondary circuit. Component Function Check 1.INSPECTIO ...

    P1723 speed sensor
    Description The secondary speed sensor detects the revolution of parking gear and generates a pulse signal. The pulse signal is sent to the TCM, which converts it into vehicle speed. The primary speed sensor detects the primary pulley revolution speed and sends a signal to the TCM. DTC Lo ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0073