Nissan Maxima Service and Repair Manual: Steering switch

Removal and Installation

REMOVAL

  1. Remove the driver airbag module. Refer to SR-12, "Removal and Installation".
  2. Remove the steering wheel audio control switch screws (A).
  3. Release the steering wheel audio control switch harness clips (B).
  4. Remove the steering wheel audio control switches (1).

Nissan Maxima. STEERING SWITCH

INSTALLATION

Installation is in the reverse order of removal.

    Satellite radio antenna
    Removal and Installation REMOVAL Lower the headlining at the rear. Refer to INT-33, "Exploded View". Disconnect the harness connector (A) from satellite radio antenna. Remove the ...

    Audio antenna
    Location of Antenna AV control unit AV control unit antenna feeder In-line connectors M103, M501 Antenna amp. Window antenna Satellite radio antenna feeder Satellite radio ante ...

    Other materials:

    Rear disc brake
    Disassembly and Assembly Union bolt Brake hose Copper sealing washer Cap Bleed valve Lower sliding pin bolt Upper sliding pin bolt Bushing Cylinder body Piston seal Piston Piston boot Retaining ring Sliding pin boot Torque member bolt Washer Torque m ...

    Oil Seal
    Removal and Installation of Valve Oil Seal REMOVAL Turn crankshaft until the cylinder requiring new oil seals is at TDC. This will prevent valve from dropping into cylinder. CAUTION: When rotating crankshaft, be careful to avoid scarring the front cover with the timing chain. Remove ...

    P0776 pressure control solenoid B
    Description The secondary pressure solenoid valve regulates the secondary pressure to suit the driving condition in response to a signal sent from the TCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: Immediately after ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0199