If you have a flat tire, refer to "Flat tire" in the "In case of emergency" section of this manual.
Wheels and tires
Tire Pressure Monitoring System
(TPMS)P0643 sensor power supply
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform
the following before conducting
the next test.
Turn ignition switch OFF and wait at least 10 seconds.
Turn ignition switch ON.
Tu ...
Hazard switch
Exploded View
Hazard switch
Cluster lid D
Removal and Installation
REMOVAL
Remove cluster lid D. Refer to IP-18, "Removal and Installation".
Disconnect the harness connector from the hazard switch and
remove.
INSTALLATION
Installation is in the reverse order of removal. ...
Vehicle jerks during VDC/TCS/ABS control
Diagnosis Procedure
1.SYMPTOM CHECK
Check if the vehicle jerks during VDC/TCS/ABS control.
2.CHECK SELF-DIAGNOSIS RESULTS
Perform self-diagnostic of ABS actuator and electric unit (control unit).
3.CHECK CONNECTOR
Turn ignition switch OFF and disconnect ABS actuator and electric
unit (co ...