Description
This CAN communication line is used to control the smooth engine operation during the TCS operation. Pulse signals are exchanged between ECM and "ABS actuator and electric unit (control unit)".
Be sure to erase the malfunction information such as DTC not only for "ABS actuator and electric unit (control unit)" but also for ECM after TCS related repair.
DTC Logic
DTC DETECTION LOGIC
NOTE:
Refer to EC-161, "DTC Logic".
Freeze frame data is not stored in the ECM for this self-diagnosis.

DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test
TESTING CONDITION: Before performing the following procedure, confirm that battery voltage is more than 10.5 V at idle.
2.PERFORM DTC CONFIRMATION PROCEDURE
Diagnosis Procedure
P1211 TCS control unit
P1217 engine over temperatureFront wiper
Exploded View
Rib (part of wiper blade refill)
Wiper blade refill
Front RH wiper blade assembly (includeswiper blade refill)
Front RH wiper arm
Wiper arm cap
Front wiper drive assembly
Front LH wiper blade assembly (includeswiper blade refill)
Front LH wiper arm <> Fron ...
Cluster lid A
Removal and Installation
REMOVAL
Using a suitable tool, gently remove the instrument side finisher
LH (1).
Remove the instrument lower panel LH (1).
Open the fuse block cover and remove the instrument lower panel
screw (A).
Disconnect the harness connectors and aspirator hose. ...
Seat belt buckle switch signal circuit
Description
Transmits a seat belt buckle switch LH signal to the combination meter.
Component Function Check
1. CHECK COMBINATION METER INPUT SIGNAL
Start engine.
Monitor seat belt warning lamp while fastening and unfastening the
driver seat belt.
Diagnosis Procedure
Regarding Wiring ...