Special Service Tools
The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here.

Commercial Service Tools


PrecautionThe oil pressure warning lamp does not turn on
Description
The oil pressure warning lamp stays off when the ignition
switch is turned ON.
Diagnosis Procedure
1.CHECK OIL PRESSURE WARNING LAMP
Perform IPDM E/R auto active test. Refer to PCS-11,
"Diagnosis Description".
2.CHECK OIL PRESSURE SWITCH SIGNAL CIRCUIT
Check the oil pressure sw ...
P1610 lock mode
Description
Performs ID verification through BCM and Intelligent Key
when push-button ignition switch is pressed.
Prohibits the start of engine when an unregistered ID of Intelligent Key is
used.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCED ...
AV branch line circuit
Diagnosis Procedure
1.CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the AV control unit for
damage, bend and loose connection (unit
side and connector side).
2.CHECK HARNESS FOR OPEN CIRC ...