Nissan Maxima Service and Repair Manual: Periodic maintenance

Preparation

Special Service Tools The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here. Commercial Service Tools ...

Fuel pressure

Inspection FUEL PRESSURE RELEASE With CONSULT Turn ignition switch ON. Perform "FUEL PRESSURE RELEASE" in "WORK SUPPORT" mode with CONSULT. Start engine. After engine stalls, crank it t ...

Other materials:

Removal and installation
POWER SOCKET Removal and Installation POWER SOCKET NOTE: If the tool does not fit because of the location of the power socket, further disassembly may be required. Refer to IP-14, "Removal and Installation". Removal Remove the fuse for the power socket. Insert one end of the Tool (A) i ...

B260A ignition relay
Description BCM turns ON the following relays to ignition power supply to each ECU when the ignition switch is turned ON. Ignition relay-1 (inside IPDM E/R) Ignition relay-2 (inside fuse block (J/B)) Front blower motor relay BCM checks any ignition relay ON request for consistency wi ...

P0868 transmission fluid pressure
Description The secondary pressure solenoid valve regulates the secondary pressure to suit the driving condition in response to a signal sent from the TCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: Immediately after ...