Nissan Maxima Service and Repair Manual: Service data and specifications (SDS)
Idle Speed
Ignition Timing
Calculated Load Value
Mass Air Flow Sensor
*: Engine is warmed up to normal operating temperature and running under no load.
Evap leak check
Inspection
CAUTION:
Never use compressed air or a high pressure pump.
Never exceed 4.12 kPa (0.042 kg/cm2, 0.6 psi) of pressure in
EVAP system.
NOTE:
Do not start en ...
Fuel system
...
Other materials:
Mirror sensor
DRIVER SIDE
DRIVER SIDE : Description
The mirror sensor LH is installed to the door mirror LH.
The resistance of 2 sensors (horizontal and vertical) is changed
when the door mirror LH is operated.
Automatic drive positioner control unit calculates the door mirror
position according to ...
B210F transmission range switch
Description
IPDM E/R confirms the shift position with the following
signals.
Transmission range switch
Shift position signal from BCM (CAN)
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC B210F is displayed with DTC
U1000, first perform the trouble diagnosi ...
Wind deflector
Removal and Installation
REMOVAL
Open the glass lid.
Remove the side screw (A) to release the wind deflector side
arms (1). : Front
Disconnect and release the inner blind (1) slide clip from wind
deflector.
: Front
Remove the front screws (A), then remove wind deflector ...
Nissan Maxima Owners Manual
- Illustrated table of contents
- Safety-Seats, seat belts and supplemental restraint system
- Instruments and controls
- Pre-driving checks and adjustments
- Monitor, climate, audio, phone and voice recognition systems
- Starting and driving
- In case of emergency
- Appearance and care
- Do-it-yourself
- Maintenance and schedules
- Technical and consumer information
Nissan Maxima Service and Repair Manual
0.0105