Nissan Maxima Service and Repair Manual: Fuel system

  • Precaution
  • PRECAUTIONS Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. This system includes seat belt switch inputs and dual stage front air bag modules. The SRS system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front air bag, depending on the severity of a collision and whether the front occupants are belted or unbelted.

  • Preparation
  • PREPARATION Special Service Tool The actual shapes of the tools may differ from those illustrated here.

  • Periodic maintenance
  • FUEL SYSTEM Inspection Inspect fuel lines, fuel filler cap and fuel tank for improper attachment, leaks, cracks, damage, loose connections, chafing or deterioration. If necessary, repair or replace damaged parts. Quick Connector CAUTION:  After connecting fuel tube quick connectors, make sure quick connectors are secure.  Ensure that connector and resin tube do not contact any adjacent parts.

  • Removal and installation
  • FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUMP ASSEMBLY Exploded View Lock ring Fuel level sensor, fuel filter and fuel pump assembly  O-ring  Fuel tank Front Removal and Installation WARNING: Read "General Precautions" before working on the fuel system. Refer to GI-27, "General Precautions". NOTE: When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spilling. REMOVAL  Unscrew the fuel filler cap to release the pressure inside the fuel tank.  Release the fuel pressure from the fuel lines. Refer to EC-592, "Inspection".  Disconnect the battery negative terminal. Remove the rear seat cushion.

  • Disassembly and assembly
  • FUEL LEVEL SENSOR UNIT Disassembly and Assembly Fuel Level Sensor Unit Harness connectors Fuel level sensor unit  Fuel tank temperature sensor  Float arm assembly Disassembly NOTE: Before disassembly, note the proper placement of the wires to the correct terminals and correct wire routing to the terminals. Disconnect the red, white, and double black wire connectors.  Press the tabs on the terminals to release the locking tabs Release the two clips and remove the fuel tank temperature sensor from the pump assembly. Release the tab (A) and slide the fuel level sensor unit and float arm assembly (B) up to remove. Assembly NOTE: Assembly is the reverse order of disassembly.

  • Service data and specifications (SDS)
  • SERVICE DATA AND SPECIFICATIONS (SDS) Fuel Tank Standard and Limit

Service data and specifications (SDS)

Precaution