Description
The electric throttle control actuator consists of throttle control motor, accelerator pedal position sensor, throttle position sensor, etc. The actuator sends a signal to the ECM, and ECM sends the signal to TCM via CAN communication.
DTC Logic
DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE
NOTE: Immediately after performing any "DTC CONFIRMATION PROCEDURE", always turn ignition switch OFF.
Then wait at least 10 seconds before performing the next test.
1.CHECK DTC DETECTION
With CONSULT
Start engine and let it idle for 5 seconds.
Perform "Self Diagnostic Results" in "TRANSMISSION".
Diagnosis Procedure
1.CHECK DTC WITH ECM
With CONSULT
Turn ignition switch ON.
Select "Self Diagnostic Results" in "ENGINE".
2.CHECK DTC WITH TCM
With CONSULT
Perform "Self Diagnostic Results" in "TRANSMISSION".
3.DETECT MALFUNCTIONING ITEMS
Check TCM connector pin terminals for damage or loose connection with harness connector.
P1723 speed sensor
P1740 select solenoidCan communication system
Component Parts Location
ABS actuator and electric unit (control
unit) E26
TCM F15
ECM E10
4. IPDM E/R E17
BCM M19
Combination meter M24
Data link connector M22
Steering angle sensor M53
Driver seat control unit B203
...
P1726 throttle control signal
Description
The electric throttle control actuator consists of
throttle control motor, accelerator pedal position sensor, throttle
position sensor, etc. The actuator sends a signal to the ECM, and ECM sends the
signal to TCM via CAN
communication.
DTC Logic
DTC DETECTION LOGIC
DTC CONF ...
Basic inspection
INSPECTION AND ADJUSTMENT
Operational Check
DESCRIPTION
The purpose of the operational check is to check that the individual system
operates normally.
Conditions: Engine running at normal operating temperature
INSPECTION PROCEDURE
1.CHECK MEMORY FUNCTION
Start the engine.
Operate the t ...