Inspection
OPERATION

With engine stopped, change vacuum to atmospheric pressure by depressing brake pedal several times. Then with brake pedal fully depressed, start engine and when vacuum pressure reaches the standard, make sure that clearance between brake pedal and floor panel decreases.
AIR TIGHT

Rear disc brake
Vacuum linesDiagnosis sensor unit
Removal and Installation
WARNING:
Before servicing, turn ignition switch OFF, disconnect both
battery terminals and wait at least 3 minutes.
Before disconnecting the air bag sensor unit harness
connector, be sure to disconnect the harness connector of each air bag
module and pre-tens ...
The ICC switch
The system is operated by the
CRUISE switch and four control
switches,
all mounted on the steering wheel.
1. DISTANCE switch:
Changes the vehicle's following distance:
Long
Middle
Short
2. RES+ switch:
Resumes set speed or increases speed incrementally.
3. CANCEL switch:
D ...
Floor trim
Exploded View
Spacer (RH)
Spacer (LH)
Floor mat hook
Floor carpet
Harness clamp Front
Removal and Installation
REMOVAL
Disconnect the negative and positive battery terminals. Refer to
PG-68, "Removal and Installation (Battery Tray)".
Remove front seat (RH/LH). Refer t ...