Brakes
PrecautionCenter speaker
Removal and Installation
REMOVAL
Remove the center speaker grille, using a suitable tool.
Remove the center speaker screws (A).
Pull out the center speaker (1), disconnect the harness connector
from the center speaker and remove.
INSTALLATION
Installation is in the reverse order ...
Condenser
Removal and Installation
REMOVAL
Remove the rear pillar finisher LH. Refer to INT-24, "Removal and
Installation".
Disconnect the harness connector, remove bolt (A), and then
remove condenser (1) from the vehicle body.
INSTALLATION
Installation is in the reverse order of ...
The oil pressure warning lamp does not turn on
Description
The oil pressure warning lamp stays off when the ignition
switch is turned ON.
Diagnosis Procedure
1.CHECK OIL PRESSURE WARNING LAMP
Perform IPDM E/R auto active test. Refer to PCS-11,
"Diagnosis Description".
2.CHECK OIL PRESSURE SWITCH SIGNAL CIRCUIT
Check the oil pressure sw ...