Diagnosis Procedure
1.CHECK START
Check front and rear brake force distribution using a brake tester.
2.CHECK FRONT AND REAR AXLE
Make sure that there is no excessive play in the front and rear axles.
3.CHECK WHEEL SENSOR AND SENSOR ROTOR
Check the following:
4.CHECK ABS WARNING LAMP DISPLAY
Make sure that the ABS warning lamp is turned off after the ignition switch is turned ON or when driving.
VDC/TCS/ABS
Unexpected pedal reactionAround View Monitor system limitations
WARNING
Listed below are the system limitations for
Around View Monitor. Failure to operate
the vehicle in accordance with these system
limitations could result in serious injury
or death.
Do not use the Around View Monitor
with the outside mirrors in the stored
position, and make ...
Door mirror motor
Description
It makes mirror face operate from side to side and up and down with the
electric power that automatic drive positioner control unit supplies.
Component Function Chec
1. CHECK DOOR MIRROR MOTOR FUNCTION
Check the operation with "MIRROR MOTOR RH" and "MIRROR MOTOR LH" in "ACTIVE
TE ...
Both side headlamps do not switch to high beam
Description
The headlamps (both sides) do not switch to high beam when the lighting
switch is in the HI or PASS setting.
Diagnosis Procedure
1.COMBINATION SWITCH (LIGHTING AND TURN SIGNAL SWITCH) INSPECTION
Check the combination switch (lighting and turn signal switch).
2.CHECK HEADLAMP (HI) ...