Diagnosis Procedure
CAUTION: The stopping distance on slippery road surfaces might be longer with the ABS operating than when the ABS is not operating.
1.CHECK FUNCTION
Turn ignition switch OFF and disconnect ABS actuator and electric unit (control unit) connector to deactivate ABS. In this condition, check stopping distance. After inspection, connect connector.
2.CHECK WHEEL SENSOR AND SENSOR ROTOR
Check the following:
3.CHECK ABS WARNING LAMP DISPLAY
Make sure that the ABS warning lamp is turned off after the ignition switch is turned ON or when driving.
Unexpected pedal reaction
ABS function does not operateHeated seat switches (if so equipped)
The front seats are warmed by built-in heaters.
1. Start the engine.
2. Push the LO or HI position of the switch, as
desired. The indicator light in the switch will
illuminate.
The heater is controlled by a thermostat,
automatically turning the heater on and off.
The indicator light ...
Front door speaker
Description
The audio unit sends audio signals to the front door speakers using the front
door speaker circuits.
Diagnosis Procedure
1.CONNECTOR CHECK
Check the audio unit and speaker connectors for the following:
Proper connection
Damage
Disconnected or loose terminals
...
P1778 step motor
Description
The step motor changes the step by turning 4
coils ON/OFF according to the signal from TCM. As a result,
the flow of line pressure to primary pulley is changed and pulley ratio is
controlled.
This diagnosis item is detected when the
electrical syste ...