Diagnosis Procedure
CAUTION: ABS does not operate when speed is 10 km/h (6 MPH) or lower.
1.CHECK ABS WARNING LAMP DISPLAY
Make sure that the ABS warning lamp turns OFF after ignition switch is turned on or when driving
2.CHECK WHEEL SENSOR AND SENSOR ROTOR
Check the following:
3.CHECK ABS WARNING LAMP DISPLAY
Make sure that the ABS warning lamp is turned off after the ignition switch is turned ON or when driving
The braking distance is long
Pedal vibration or abs operation sound occursB2634, B2635 air mix door motor (passenger side)
Description
COMPONENT DESCRIPTION
Air Mix Door Motor (Passenger Side)
The air mix door motor (passenger side) (1) is attached to the
heater & cooling unit assembly.
It rotates so that the air mix door is opened or closed to a
position
set by the A/C auto amp.
Motor rotation is t ...
Brake pedal
Exploded View
Clevis pin
Snap pin
Stop lamp switch
ASCD cancel switch
Clip
Brake pedal assembly
Brake pedal pad
NOTE:
The clevis pin must be installed from the RH side as shown.
Removal and Installation
REMOVAL
Remove instrument lower panel LH and lower knee protec ...
Engine speed signal circuit
Description
ECM sends engine speed signal to power steering control unit.
Diagnosis Procedure
1.PERFORM ECM SELF-DIAGNOSIS
With CONSULT
Perform ECM self-diagnosis.
2.CHECK HARNESS BETWEEN ECM AND POWER STEERING CONTROL UNIT FOR OPEN
Turn the ignition switch OFF.
Disconnect ECM connec ...