Nissan Maxima Service and Repair Manual: Occupant classification system control unit

Nissan Maxima Service and Repair Manual / Restraints / SRS airbag / Removal and installation / Occupant classification system control unit

Removal and Installation

Removal and Installation

The occupant classification system control unit and sensor mat are an integral part of the front passenger seat cushion, and are replaced as an assembly only. Refer to SE-68, "Removal and Installation" (WITH CLIMATE CONTROL), or SE-126, "Removal and Installation" (W/O CLIMATE CONTROL).

CAUTION: Do not disassemble the seat trim from the seat cushion foam.

    Diagnosis sensor unit
    Removal and Installation WARNING: Before servicing, turn ignition switch OFF, disconnect both battery terminals and wait at least 3 minutes. Before disconnecting the air bag sensor unit harn ...

    SRS airbag control system
    ...

    Other materials:

    Air Cleaner And Air Duct
    Removal and Installation Air duct hose and resonator assembly Front air duct Air cleaner case (lower) Grommets Air cleaner case mounting bracket Bracket Air cleaner filter Air cleaner case (upper) Mass air flow sensor  To electric throttle control actuator ...

    Changing wheels and tires
    Tire rotation NISSAN recommends rotating the tires every 5,000 miles (8,000 km). For additional information on tire replacing procedures, refer to "Flat tire" in the "In case of emergency" section of this manual. As soon as possible, tighten the wheel nuts to the specified torque with ...

    Parking, license plate and tail lamps
    System Diagram System Description BCM (Body Control Module) controls parking, license plate and tail lamps operation. IPDM E/R (Intelligent Power Distribution Module Engine Room) operates parking, license plate and tail lamps according to CAN communication signals from BCM. Comp ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0082