DIAGNOSIS AND REPAIR WORK FLOW
WITH COLOR DISPLAY
WITH COLOR DISPLAY : How to Perform Trouble Diagnosis For Quick And Accurate Repair
WORK FLOW
1.LISTEN TO CUSTOMER COMPLAINT
Interview the customer to obtain as much information as possible about the conditions and environment under which the symptom occurs.
2.CHECK FOR SERVICE BULLETINS
Check for any service bulletins
3.CHECK FOR HVAC DTCS WITH CONSULT
Using CONSULT, perform "SELF-DIAGNOSIS RESULTS" of HVAC.
4.CHECK FOR AUDIO DTCS WITH CONSULT
Using CONSULT, perform "SELF-DIAGNOSIS RESULTS" of MULTI AV
5.PERFORM OPERATIONAL CHECK
Verify the symptom with operational check based on the information obtained from the customer.
6.GO TO APPROPRIATE TROUBLE DIAGNOSIS
Go to appropriate trouble diagnosis.
7.FINAL CHECK
Check that the A/C system operates normally.
WITH MONOCHROME DISPLAY
WITH MONOCHROME DISPLAY : How to Perform Trouble Diagnosis For Quick And Accurate Repair
WORK FLOW
1.LISTEN TO CUSTOMER COMPLAINT
Interview the customer to obtain as much information as possible about the conditions and environment under which the symptom occurs.
2.CHECK FOR SERVICE BULLETINS
Check for any service bulletins.
3.CHECK FOR HVAC DTCS WITH CONSULT
Using CONSULT, perform "SELF-DIAGNOSIS RESULTS" of HVAC.
4.PERFORM OPERATIONAL CHECK
Verify the symptom with operational check based on the information obtained from the customer.
5.GO TO APPROPRIATE TROUBLE DIAGNOSIS
Go to appropriate trouble diagnosis.
NOTE: If DTC is displayed, erase DTC after repairing or replacing malfunctioning parts.
6.FINAL CHECK
Check that the A/C system operates normally.
System description
Symptom diagnosisSTRG branch line circuit
Diagnosis Procedure
1.CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the steering angle sensor
for damage, bend and loose connection
(unit side and connector side).
2.CHECK HARNESS FOR OPE ...
P1709 incompleted data writing
Description
When TCM does not store calibration data (individual
characteristic value) of each solenoid valve that is
stored in the ROM assembly (in the control valve), a malfunction is detected.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
NOTE:
Immediately after performing ...
Power control system
System Diagram
System Description
COOLING FAN CONTROL
IPDM E/R controls cooling fans according to the status of the cooling fan
speed request signal received from
ECM via CAN communication.
GENERATOR CONTROL
IPDM E/R outputs power generation command signal (PWM signal) to the
generat ...