Nissan Maxima Service and Repair Manual: Unit disassembly and assembly

Climate controlled seat blower filter

Removal and Installation REMOVAL CAUTION: When removing and installing, use shop cloths to protect parts from damage. Remove front seat. Refer to SE-68, "Removal and Installation". Turn blo ...

Front seat

DRIVER SIDE DRIVER SIDE : Exploded View Driver Seat - With Climate Controlled Seats Seatback board Seatback board clip Seat cushion lower rear finisher Seat harness Seat cushion inn ...

Other materials:

Rear lower link & coil spring
Removal and Installation Removal Remove the rear wheel and tire using power tool. Refer to WT-60, "Adjustment". Loosen the rear lower link adjusting bolt and nut at the rear suspension member. Support the rear lower link with a suitable jack. Support the rear axle housing with a ...

Telescopic sensor
Description The telescopic sensor is installed to the steering column assembly. The pulse signal is input to the driver seat control unit when telescopic is performed. The driver seat control unit counts the pulse and calculates the telescopic amount of the steering column. Componen ...

Power supply and ground circuit
Diagnosis Procedure 1. CHECK FUSE AND FUSIBLE LINK Check if the following BCM fuses or fusible link are blown 2. CHECK POWER SUPPLY CIRCUIT Turn ignition switch OFF. Disconnect BCM. Check voltage between BCM harness connector and ground. 3. CHECK GROUND CIRCUIT Check continuit ...