Preliminary Check
1. FOREIGN OBJECTS
Check the following:
Are there any foreign objects that could be causing interference?
2. WIRING CONNECTIONS
Are any connectors damaged or loose?
3. POWER AND GROUND
Check power supply and ground circuits for control unit. Refer to ADP-47, "DRIVER SEAT CONTROL UNIT : Diagnosis Procedure".
Is the inspection result normal?
Special Repair Requirement
Refer to Owner's Manual for Automatic Drive Positioner system operating instructions.
Diagnosis and repair workflowLocking doors
1. Place the ignition switch in the LOCK position.
2. Close all doors.
3. Press the button on the
Intelligent
Key.
4. The hazard warning lights flash twice, the
horn beeps once, and the front and tail lights
will turn on for 10 seconds.
5. All doors will be locked.
CAUTION
Af ...
Combination meter
Reference Value
VALUES ON THE DIAGNOSIS TOOL
NOTE:
* The monitor will indicate "OFF" even though
the brake warning lamp is on if either of the following conditions exist:
The parking brake is engaged
The brake fluid level is low
TERMINAL LAYOUT
PHYSICAL VALUES
...
ECU diagnosis information
BCM (BODY CONTROL MODULE)
Reference Value
NOTE: The Signal Tech II Tool (J-50190) can be used
to perform the following functions. Refer to the Signal Tech II User Guide
for additional information.
Activate and display TPMS transmitter IDs
Display tire pressure reported by the ...