Inspection and adjustment
Automatic drive positioner systemECM branch line circuit
Diagnosis Procedure
1.CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the following terminals and connectors for damage, bend and
loose connection (unit side and connector
side).
- Models without automatic drive position ...
Canceling a remote start
To cancel a remote start, perform one of the
following:
Aim the Intelligent Key at the vehicle and
press until the parking lights
turn off.
Turn on the hazard warning flashers.
Cycle the ignition switch ON and then OFF.
The extended engine run time has expired.
The first 10 minute ...
How to erase permanent DTC
Description
OUTLINE
When a DTC is stored in ECM
When a DTC is stored in ECM and MIL is ON, a permanent DTC is erased with MIL
shutoff if the same malfunction
is not detected after performing the driving pattern for MIL shutoff three times
in a raw.
*1: When the same malfunction is detect ...