Nissan Maxima Service and Repair Manual: Key slot

Description

Detects whether Intelligent Key is inserted.

Immobilizer antenna amp checks Intelligent Key transponder.

Component Function Check

1. CHECK FUNCTION

With CONSULT

Check KEY SW -SLOT in Data Monitor mode with CONSULT.

Nissan Maxima. CHECK FUNCTION

Diagnosis Procedure

1. CHECK KEY SLOT POWER SUPPLY CIRCUIT

  1. Turn ignition switch OFF.
  2. Disconnect key slot connector.
  3. Check voltage between key slot connector and ground.

Nissan Maxima. CHECK KEY SLOT POWER SUPPLY CIRCUIT

2. CHECK KEY SLOT GROUND CIRCUIT

Nissan Maxima. . CHECK KEY SLOT GROUND CIRCUIT

Check continuity between key slot connector and ground.

Nissan Maxima. . CHECK KEY SLOT GROUND CIRCUIT

3. CHECK KEY SLOT CIRCUIT

Nissan Maxima. CHECK KEY SLOT CIRCUIT

  1. Disconnect BCM connector.
  2. Check continuity between BCM connector and key slot connector.
  3. Check continuity between BCM connector and ground.

Nissan Maxima. CHECK KEY SLOT CIRCUIT

Nissan Maxima. CHECK KEY SLOT CIRCUIT

4. CHECK KEY SLOT

5. CHECK INTERMITTENT INCIDENT

Component Inspection

1. CHECK KEY SLOT

Check key slot.

Nissan Maxima. CHECK KEY SLOT

    Door lock and unlock switch
    DRIVER SIDE DRIVER SIDE : Description Transmits door lock/unlock operation to BCM. DRIVER SIDE : Component Function Check 1. CHECK FUNCTION With CONSULT Check CDL LOCK SW, CDL UNLOCK SW in Data ...

    Key cylinder switch
    Description The main power window and door lock/unlock switch detects condition of the door key cylinder switch and transmits to BCM as the LOCK or UNLOCK signal. Component Function Check 1. C ...

    Other materials:

    Hazard switch
    Component Function Check 1.CHECK HAZARD SWITCH SIGNAL BY CONSULT CONSULT DATA MONITOR Turn ignition switch ON. Select "HAZARD SW" of BCM (FLASHER) DATA MONITOR item. With operating the hazard switch, check the monitor status. Diagnosis Procedure 1.CHECK HAZARD SWITCH SIGNAL INPUT ...

    B2193 chain of ECM-IMMU
    Description BCM performs the ID verification with ECM that allows the engine to start. Start the engine if the ID is OK. ECM prevents the engine from starting if the ID is not registered. BCM starts the communication with ECM if ignition switch is turned ON. DTC Logic DTC DETECTION LOGIC ...

    Periodic maintenance
    IN-CABIN MICROFILTER Removal and Installation REMOVAL Disengage the filter cover tab (1) by pushing up and pull out to remove the filter cover. Remove the in-cabin microfilter from the blower unit. INSTALLATION Installation is in the reverse order of removal. ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.007