Nissan Maxima Service and Repair Manual: Hazard function

Description

Perform answer-back for each operation with number of blinks.

Component Function Check

1. CHECK FUNCTION

Check hazard warning lamp ("FLASHER") in Active Test.

Diagnosis Procedure

1. CHECK HAZARD SWITCH CIRCUIT

Operate the hazard lights by turning ON the hazard warning switch.

2. CHECK INTERMITTENT INCIDENT

    Warning chime function
    Description Performs operation method guide and warning with buzzer. Component Function Check 1. CHECK FUNCTION With CONSULT Check the operation with "INSIDE BUZZER" in the Active Test. To ...

    Homelink universal transceiver
    Description Homelink universal transceiver can store and transmit a maximum of 3 radio signals. Allows operation of garage doors, gates, home and office lighting, entry door locks and securit ...

    Other materials:

    Headlamp (LO) circuit
    Description The IPDM E/R (intelligent power distribution module engine room) controls the headlamp low relay based on inputs from the BCM over the CAN communication lines. When the headlamp low relay is energized, power flows through fuses 51 and 52, located in the IPDM E/R. Power then flows ...

    Programming trouble-diagnosis
    If the HomeLink does not quickly learn the hand-held transmitter information: replace the hand-held transmitter batteries with new batteries. position the hand-held transmitter with its battery area facing away from the HomeLink surface. press and hold both the HomeLink and hand-hel ...

    Tire pressure receiver
    Removal and Installation REMOVAL Remove instrument lower panel LH. Refer to IP-11, "Removal and Installation". Locate tire pressure receiver (1) to the right of the steering column and disconnect the harness connector from the tire pressure receiver. Remove tire pressure receiver ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2023 Copyright www.nimainfo.com
    0.006