Removal and Installation
REMOVAL

INSTALLATION
Installation is in the reverse order of removal
Door switch
Trunk opener request switchMain line between ADP and DLC circuit
Diagnosis Procedure
1.CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the following terminals and connectors for damage, bend and
loose connection (connector side
and harness side).
Harness connector B1
Harness connect ...
Line pressure test
Inspection and Judgment
INSPECTION
Line Pressure Test Procedure
Inspect the amount of engine oil and replenish
if necessary.
Drive the car for about 10 minutes to warm it
up so that the CVT fluid reaches in the range of 50 to 80C
(122 to 176F). Then inspect the ...
U1300 AV comm circuit
Description
U1300 is indicated when a communication signal malfunction occurs. U1300 is
indicated along with DTCs that identify components connected to the AV
control unit through communication lines. Determine the possible malfunction
cause from the table below.
SELF-DIAGNOSIS RESULTS DISPL ...